Processing steps :
The surface should be clean off such as existing sealers, curing materials, grease, oil, and dirt.
Use the solvent based for the concrete whose moisture content is below 8%; use the water based for the concrete whose moisture content is 8% to 16%.
Solvent based:After mixing 1050A/B(the mixing ratio is 2:1) evenly, brush or spread on the floor and leave it until dry before apply second layer.
Water based:Stirring water and 3118(hardener)(the mixing ratio is 1:1) evenly then mixing 1010 (the ratio is 1). Brush or spread on the floor and leave it until dry before apply second layer
Resin floating method : Mixing 1030/2108-W (for winter), 1030/2108(for summer) or 1030/5340 (chemical resistance) evenly with the mixing ratio 2:1. Adding #9 silicon sand in it if needed. Smooth the surface and wait until dry before apply top coating.
Resin mortar method : Mixing 1010/2108 evenly with the mixing ratio 2:1. Adding 3~5 times #9 silicon sand in ti. Smooth the surfaces and wait until dry before apply top coating.
Putty : If the surface is uneven, use 1351A/1351B(the mixing ratio 1:1) to create an even surface.
Top coating operating : Trowel epoxy resin(color can be changed) and hardener by the ratio 3:1 or 5:1; then wait until fully cured (3 days).